Publicité
1 Liability of press owner and/or user
This manual is an integral part of the press and must always accompany it, even in the event of sale. The press owner
and/or user must know the operating instructions and recommendations before using the press. If the operator does
not fully understand the language of this manual, the instructions have to be read and explained in his or her native
language making sure the meaning is understood.
The manufacturer shall not be held liable for any damage to persons or objects due to an improper
or no permitted use of the press.
2 Packing
The press is shipped in a single pack protected by bubble plastic film.
Weights of press: 210 kg.
3 Lifting and handling
The press has to be handled and positioned using a fork-lift truck or a workshop crane that support the weight.
The packing has to be kept in a covered and sheltered place at a temperature between -10 °C and +40 °C.
4 Safety
•
Do not use the press for purposes other than those for which it was designed.
•
Do not work alongside pieces while the ram is moving or when it is under pressure.
•
The safety valve is calibrated and sealed by the manufacturer. Do not attempt to tamper with it and change
the setting. Failure to observe these recommendations may cause even serious damage to the press and/or to the
persons working with it.
5 Installation
•
Take the press out of the packing, checking that the machine has not been damaged during transport and that there
are all the pieces indicated in the packing list. The packing material has to be disposed of in compliance with the
regulations in force in the country where the press is being erected or recycled or reused.
•
Position the press on a flat and fully levelled surface. Inside the feet there are two holes for fixing to the ground by
using expansion plugs of a large cross-section.
•
Fit the feet to the body of the press by screwing them on with the nuts and bolts supplied (Fig. 1). Then fix the press to
a solid bench of a suitable capacity load, locking it by means of through bolts and nuts to the workbench.
•
Spread a thin film of oil on the press workbench support pins.
6 Operation
•
Position the bed of the press (ref. 1, fig. 6) at the desired height, lifting it first on one side and inserting one of the
pins (ref. 2, fig. 6) into the hole in the press body directly beneath, then repeating this step for the other side as well.
•
Position the pins (ref. 2, fig. 6) at the desired point.
•
Position the prisms (ref. 3, fig. 6) on the bed (ref. 1, fig. 6).
•
Insert the lever of the pump (ref. 4, fig. 6) into its relative seat (ref. 5, fig. 6) on the pump.
•
Fig. 7 shows the uses relative to the positions of the two dials on the pump.
•
Operate the lever to lower the ram, carry out the work then bring the ram back to rest with the relative dial (Fig. 7).
The pump operating lever is thereby free to be able to be extracted or moved if it gets in the way of work on the
press.
6
M1.3.CATOMA20S.NLFREN 14032019
EN
Publicité
