Alto Professional Stealth Wireless Guide D'utilisation page 7

Dual Channel Setup
To send stereo signals through the Stealth Wireless transmitter to two receivers:
1. Connect your mixer's
connect the Stealth Wireless receivers' outputs to your loudspeaker's inputs.
volume and transmitter Trim controls at a minimum.
2. Power on the Stealth Wireless transmitter and receiver.
3. Adjust the transmitter and receiver antennas to a vertical position.
4. Set the transmitter to "stereo" and adjust the Trim controls to get a strong signal without
clipping.
5. Turn on your loudspeaker, adjust the output level of your mixer, and adjust the Trim controls on
the transmitter to hear the audio signal. If
channel until a clean signal comes through.
This diagram shows the
signal flow from a mixer,
through Stealth Wireless,
to speakers.
Powered
Speaker
main outputs to the input channels
Receiver
Transmitter
on the Stealth Wireless transmitter, and
Set their channels to matching numbers.
you hear noise in the
Receiver
Mixer
7
Keep all mixer
signal, change to a different
Powered
Speaker