Connection Diagrams - Alto Professional Stealth Wireless Guide D'utilisation

Connection Diagrams

Single Channel Setup
To send mono signals through the Stealth Wireless transmitter to a single receiver:
1. Connect your mixer's main output to an input on the Stealth Wireless transmitter, and connect
the receiver's output to your loudspeaker's input. Keep all mixer volume and transmitter Trim
controls their minimum settings.
2. Power on the Stealth Wireless transmitter and receiver.
3. Adjust the transmitter and receiver antennas to a vertical position.
4. Set the transmitter to "mono" and adjust
5. Turn on your loudspeaker, adjust the output level on your mixer, and adjust the Trim controls on
the transmitter to hear the audio signal. If
channel until a clean signal comes through.
This diagram shows
the signal flow from a
mixer, through Stealth
Wireless, to a speaker.
the Trim control to get a strong signal without clipping.
Receiver
Transmitter
Mixer
Set their channels to matching numbers.
you hear noise in the
Powered
Speaker
6
signal, change to a different