Serie 100 - H 100/6m
2.4 USO IN SICUREZZA
I banchi della SERIE 100 - H 100 si compongono essenzialmente di tre
parti, banco con sollevatore a pantografo, sistema di tiro e Dima
Universale SUPERSTAR. Si raccomanda di leggere le prescrizioni di
sicurezza riportate di seguito e di leggere anche attentamente le medesime
prescrizioni sui libretti di uso e manutenzione della pompa e del verricello
(se fornito in dotazione):
AVVERTENZA
La SPANESI S.p.A. declina qualsiasi responsabilità per danni
causati dalla mancata osservanza delle norme di sicurezza e di
prevenzione infortuni di seguito descritte.
•
È vietato azionare o fare azionare a chiunque non abbia letto completamente,
compreso ed assimilato perfettamente quanto riportato nel presente manuale.
•
È vietato azionare o fare azionare la macchina da personale non adeguatamente
addestrato e competente o non in buone condizioni di salute.
•
È vietato oltrepassare le portate indicate nelle tabelle del presente libretto: il
sovraccarico della macchina comporta il pericolo grave di rotture e la perdita della
garanzia.
•
È vietato applicare alla macchina puntoni di caratteristiche diverse da quelle indicate
nel presente libretto o non forniti dalla SPANESI S.p.A.: l'impiego di puntoni non
originali comporta il pericolo grave di rotture e la perdita della garanzia.
•
È vietato toccare, appoggiarsi o interposi fra le parti in movimento durante
le manovre di salita o discesa del sollevatore.
•
È vietato sollevare persone, animali o cose: il sollevatore è costruito esclusivamente
per il sollevamento di veicoli entro il limite di portata indicato
nella tabella delle portate.
•
È vietato sollevare il veicolo con a bordo persone o oggetti instabili, che cadendo
possono provocare danni a persone o cose.
•
È vietato sollevare il veicolo con puntone di tiro inserito nel banco.
•
È vietato per chiunque passare o stazionare dietro i puntoni di tiro quando sono in
tensione. Quando si mette il puntone di tiro in tensione l'operatore deve mantenersi
ad una distanza di almeno 1 metro dal puntone stesso.
•
È vietato usare scale, sgabelli o altri oggetti per appoggiarsi durante le manovre di
messa in tensione del puntone di tiro: durante le operazioni l'operatore deve
mantenersi sempre solidamente appoggiato al suolo.
•
È obbligatorio verificare che il gancio di sicurezza posto sotto la base del puntone,
sia ben agganciato.
•
È obbligatorio quando si effettua l'operazione di tiro usare l'apposita fune di
sicurezza.
•
È obbligatorio montare i bracci di tiro quando il sollevatore è
completamente basso (le ruote del puntone devono poggiare a terra)
•
È obbligatorio effettuare le operazioni di tiro con il sollevatore
completamente basso (le ruote del puntone devono poggiare a terra)
•
È obbligatorio verificare durante le operazioni di tiro che persone o animali non
stazionino o passino occasionalmente vicino ai puntoni o ai bracci di tiro.
•
È obbligatorio controllare la perfetta integrità di tutti i dispositivi di sicurezza e
la struttura del sollevatore prima di utilizzare la
•
È obbligatorio verificare prima di mettere in funzione il banco che persone non
vengano a trovarsi all'interno del sollevatore o a meno di un metro di distanza
attorno ad esso.
•
È obbligatorio che il veicolo da sollevare sia condotto o manovrato solamente da
personale idoneo alla guida, come previsto dalle leggi sulla Circolazione Stradale in
vigore nel Paese in cui viene utilizzato il sollevatore.
•
È obbligatorio verificare che gli sportelli del veicolo posizionato sul banco siano
chiusi. Non devono sporgere oggetti al di fuori della sagoma della macchina.
•
È obbligatorio, prima di eseguire la manovra di discesa, verificare che sotto e
intorno al veicolo non vi siano oggetti: eventualmente rimuoverli.
•
È obbligatorio verificare, prima di eseguire la manovra di discesa, che eventuali
tubazioni o cavi elettrici degli utensili da lavoro non siano posizionati in modo tale da
venire schiacciati.
•
È obbligatorio verificare che la base del sollevatore, in cui va ad
macchina.
2.4 SAFE USE
The SERIE 100 - H 100 benches consist basically of three parts, bench
with scissor lift, pull system and SUPERSTAR Universal Jig. After
reading the safety precautions given below, you should also carefully read the
precautions contained in the operation and service manuals of the pump
and the winch (if provided):
SPANESI S.p.A. accepts no liability for damage caused by failure
to observe the safety precautions and accident-prevention
directions set out below.
•
The machine must never be operated by anyone who has not completely
read, understood and assimilated the contents of this instruction manual.
•
The machine must never be operated by inadequately trained or inexpert
personnel or personnel not in good health.
•
Never exceed the capacities specified in the tables given in this manual: overloading
can lead to breakage of the machine and loss of the
•
Never fit pull bars with characteristics different from those specified in this manual
or not supplied by SPANESI S.p.A.: the use of non-original pull bars can lead to
breakage of the machine and loss of the
•
Never touch, rest on or stand between the moving parts during raising and lowering
of the lift.
•
Never lift persons, animals or things: the lift is designed exclusively for lifting vehicles
within the limits specified in the table of capacities.
•
Never raise the vehicle with persons or unstable objects on board which can fall off
and injure persons or damage property.
•
Never raise the vehicle with pulling tower mounted on the bench.
•
Persons must never pass or stand behind the pull arms when under tension. When
the pull arm is under tension, the operator must keep a distance of at least 1 metre
from the pull bar.
•
Never use ladders, stools or other objects when tensioning the pull arm. The
operator must always remain on the ground.
•
Always check that the safety hook located below the base of the pull bar is secured.
•
Always use the safety cable when performing pull operations.
•
Always fit the pull arms when the lift is fully lowered.
•
Always remove or refit parts of the vehicle when the lift is fully lowered.(in case of
bench with pulling tower)
•
Always perform the pull operations with the fully lowered lift (the pulling columns
wheels must rest on the ground)
•
Always check that during pull operations there are no persons or animals standing or
passing near the pull bars or arms.
•
The condition of all the safety devices and the structure of the lift must
be checked before using the machine.
•
Before starting the bench, always check that there is no-one on the lift or less than
one metre from the perimeter of the machine.
•
The vehicle to be lifted must be driven or moved only by persons qualified to
drive in accordance with the traffic laws in force in the country in which the lift
is being used.
•
Always check that the doors of the vehicle positioned on the bench are closed.
There must be nothing protruding from the machine.
•
Before lowering the lift, always check that there are no objects below or around the
vehicle and remove if necessary.
•
Before lowering the lift, always check that there are no hoses or tool cables in
the area that can be squashed.
•
The bench must be installed by qualified personnel following the
instructions given in this manual.
•
The bench must be housed in a place protected from rain and ice: the machine has
been designed and built to operate indoors only. The machine must only be used
inside premises where there is no danger of explosion or fire.
•
Always check that the floor on which the bench rests is smooth and level.
•
Always check that the area of the building above the bench is not occupied by
electrical equipment connected to the mains otherwise electrical discharges may
occur if the vehicle collides or comes into contact with the equipment.
•
The control unit console must be positioned at a safe distance from the bench,
providing a full view of the work area.
•
Before beginning work you are advised to become familiar with the
46
WARNING
warranty.
warranty.