V2 CITY11 Manuel page 13

ADJUSTMENT OF THE POWER AND
OPERATIONAL TIMES
The power and operating times may be adjusted by means of 4
trimmers located on the control unit:
m
PLEASE NOTE: it is recommended that operating times
be set with the slow down function disabled (DIP 5 OFF).
m
WARNING: the adjustment of times has to be made
when the gate is still
MIN MAX
POWER
18"
2" 45"
WORK
2" 50"
30"
2" 90"
PAUSE
2" 150"
15"
0 45"
DELAY
0 90"
CONTROL UNIT INDICATORS (LEDs)
The highlighted boxes indicate the state of the LEDs when the gate is resting.
LED
START
START P.
STOP
PHOTO
EDGE
Edge NO pressed: 8K2 between EDGE input and
mains
overload
POWER: motor power
WORK: motor operating time
(2 - 50 seconds)
PAUSE: pause time before
automatic re-closure
(2 - 150 seconds).
DELAY: time delay between the
two gate leaves (0 - 90 seconds).
ON
START input closed
START P. input closed
STOP input closed
PHOTO input closed
EDGE input closed (edge not pressed)
EDGE input closed (edge pressed)
common (-)
Control unit powered-up
Accessory power supply overload
CABLE GLAND ASSEMBLY
The casing can accept 4 cable glands in the special easy-break
housings. The type of cable gland is indicated in the figure.
m
PLEASE NOTE:
• Remove the electronic circuit board before drill the casing.
• Drill the container using a suitably sized cutter, according to the
dimensions of the cable gland.
• Fix the cable glands using the special nuts.
PG9 - PG11
PG9 - PG11 - PG16
Standard edge
EDGE input open (edge pressed)
Resistive rubber edge
Control unit NOT powered-up
Accessory power supply within normal operational limits
- 11 -
OFF
START input open
START P. input open
STOP input open
PHOTO input open
EDGE input open (fault)