VONROC GT502AC Traduction De La Notice Originale page 8

EN
5. Power cable
6. Upper housing
7. Lower housing
8. Protection guard
9. Spool assembly
10. Housing screw
11. Protection guard screw
12. Notch
13. Blade
14. Spool cover
15. Wire spool
16. Spring
17. Spool holder
3. ASSEMBLY
Cut injury when the unit starts accidentally.
Before you assemble the unit, make sure
that the mains cable is disconnected.
Assembling the housing (Fig. A, B, C)
1. Insert the lower housing (7) into the upper
housing (6), as shown on figure B. Ensure that
the cable is not stretched or caught when you
do this.
2. Secure both housing parts using the housing
screws (10), as shown on figure C. Use a screw
on both sides of the housing.
Mounting the protection guard (Fig. A, D)
1. Put the protection guard (8) onto the lower hou-
sing (7) by first putting the guard into the notch
(12) and afterwards pulling the guard upwards.
2. Now secure the protection guard using the pro-
tection guard screw (11). A correctly assembled
protection guard is shown on figure D.
Replacing the wire spool (Fig. F1)
Before replacing the spool clean the
machine from any dirt.
• Remove the spool cover (14) by pressing the
two buttons on each side of the spool cover.
• Take out the spool reel (15) but leave the spring
(16) inside.
• Take the new spool reel (GT802AA) and place
it over the spring (16). Make sure the wires
are passed through the holes inside the spool
holder (17).
8
• Cover the new spool reel with the spool cover
(14) and make sure the buttons of the spool
cover (14) align properly with the holes inside
the spool holder (17).
4. OPERATION
Using the tap and go system (Fig. A, D)
To enable the tap and go system, the plastic cover
in front of the blade (13) in the protection guard (8)
must be removed.
Do not touch the blade (13) in the
protection guard (8) to prevent injury.
• When the wire is too short, switch the machine
on and press the tip of the spool reel (15) on
the ground (make sure this is done on a hard
surface).
• This will release the wire in order to get longer.
• The wire will be cut on the correct length
automatically by the blade (13) mounted in the
protection guard (8).
Using the cord grip (fig. A, E)
To help secure the plug to the extension cord,
make a loop in the extension cord and attach it to
the cable hook as shown (see Fig. E). Once secure,
attach the cord to the plug. This will prevent acci-
dental 'pull-out'.
Using the trimmer
Before use, always visually inspect the
machine and its parts are correctly
mounted, not worn out or damaged.
Hold the unit by the top part of the handle (1) and
the front handle (4) so that the trimmer head is
tilted a small distance forward. Make sure, the
filament does not touch hard objects such as walls,
stones and fences to prevent the filament from
welding together or breaking.
Switching On and Off (fig. A)
• To switch the trimmer on, press the on/off
switch (2).
• To switch off, simply release the on/off switch
(2).
WWW.VONROC.COM