VONROC GT502AC Traduction De La Notice Originale page 7

• Always disconnect the trimmer from the mains
when leaving the trimmer unattended.
• After extending new cutter line or replacing
the spool line. Always return the trimmer to its
normal operating position before switching on.
• Periodically inspect the condition of the cutting
head. If the spool is damaged, switch off, remo-
ve the plug from the power point and replace
the spool.
• Do not use the machine to cut grass, which
is not on the ground. For example, do not cut
grass, which is on walls or rocks.
• Do not cross roads or gravel paths with machine
still running.
• Only use the machine according to the instructi-
ons given in this manual.
• Do not extend the trimming line beyond the
guard and do not operate the trimmer without
both lines extended and proper line installed.
• Check regularly that the nuts, bolts and screws
are tight.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
type X: If the supply cord is damaged, it must be re-
placed by a special cord or assembly available from
the manufacturer or its service agent.
type Y: If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.
2. MACHINE INFORMATION
Intended use
This grass trimmer is intended for outdoor use, to
trim and to cut grass and lawns in private and hob-
by gardens. The product is designed cutting grass,
light weeds and other similar vegetation at or about
ground level. The trimmer should not be used to cut
WWW.VONROC.COM
or trim hedges, bushes or other vegetation where
the cutting plane is not at or about ground surface
level. Do not use the trimmer to shred or to make
compost. Do not use this machine in the rain.
TECHNICAL SPECIFICATIONS
Model no.
Voltage
Frequency
No load speed
Cutting diameter
Cutting system
Weight
Sound pressure level L
PA
Sound power level L
WA
Vibration value
Guaranteed value according to the noise directive:
LwA 96db(A)
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardized test given in EN 60335-1 and
EN 50636-2-91; it may be used to compare one
tool with another and as a preliminary assessment
of exposure to vibration when using the tool for the
applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-5.
1. Handle
2. On/off switch
3. Cable hook
4. Front handle
GT502AC
230V
50Hz
11.500/min
230 mm
2 line wire spool,
Tap and go Ø1.2mm x 4m
1,26 kg
80.4 dB(A) K=3 dB(A)
89.4 dB(A) K=1.96 dB(A)
2.1 m/s² K=1.1 m/s²
7
EN