Télécharger Imprimer la page

JVC KD-S9R Manuel D'instructions page 13

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 62
To activate programme search, follow the procedure
below.
• Programme search takes a while.
• See also "Changing the general settings (PSM)"
on page 19.
1
Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or
2
Press
"P(Programme)-SEARCH."
3
Rotate the control dial clockwise to select "ON."
Now programme search is activated.
To cancel programme search, repeat the same
procedure and select "OFF" in step 3 by rotating the
control dial counterclockwise.
Changing the display mode while
listening to an FM station
You can change the initial indication on the display
to either station name (PS NAME) or to station
frequency (FREQ), while listening to an FM RDS
station.
• See also "Changing the general settings (PSM)"
on page 19.
1
Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or
2
Press
(tuner display)."
3
Rotate the control dial to set to the desired
indication ("PS NAME" or "FREQ").
Note:
By pressing DISP, you can also change the display while
listening to an FM RDS station.
Each time you press the button, the following information
appears on the display:
Station name
(PS NAME)
Programme type
(PTY)
• Then, the display goes back to the original indication
in several seconds.
4 to select
4 to select "TU DISP
Station frequency
(FREQ)
Setting the TA volume level
You can preset the volume level for TA Standby
Reception. When a traffic programme is received,
the volume level automatically changes to the preset
level.
• See also "Changing the general settings (PSM)"
on page 19.
1
Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or
2
Press
3
Rotate the control dial to set to the desired
volume.
You can set it from "VOL 00" to "VOL 50."
Automatic clock adjustment
When shipped from the factory, the clock built in
this unit is set to be readjusted automatically using
the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock
adjustment, follow the procedure below.
• See also "Changing the general settings (PSM)"
on page 19.
1
Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.
¢ or
2
Press
3
Rotate the control dial counterclockwise to select
"OFF."
Now automatic clock adjustment is canceled.
To reactivate clock adjustment, repeat the same
procedure and select "ON" in step 3 by rotating the
control dial clockwise.
Note:
It takes about 2 minutes to adjust the time using the CT
data. So, you should not change the station for more
than 2 minutes continuously; otherwise, the clock time
will not be adjusted.
4 to select "TA VOL."
4 to select "AUTO ADJ."
13

Publicité

loading