MW TOOLS WD70 Mode D'emploi page 24

Ignition Electrodes
Ignition electrodes
Clean, adjust and if necessary replace ignition electrode. For electrode gaps see Fig. 4-5 (dimensions
Clean, adjust and if necessary replace ignition electrodes. For electrode gaps see figures 4 - 5 (dimensions in mm).
in mm).
Ignition Electrodes
Clean, adjust and if necessary replace ignition electrode. For electrode gaps see Fig. 4-5 (dimensions
in mm).
Figure 4
Fig.4
Compressor pressure adjustment (figure 6)
Compressor Pressure Adjustment (Fig. 6)
WARNING!
The compressor pressure is factory set and must be checked and adjusted by qualified
The compressor pressure is factory set and must be checked and adjusted by qualified technicians
technicians only. Tampering with the unit may be dangerous.
Fig.4
only. Tampering with the unit may be dangerous.
Remove pressure gauge cap. Connect a pressure gauge on the pressure measuring port on the rear
Remove pressure gauge cap. Connect a pressure gauge on the pressure measuring port on the rear guard. Start heater and
guard. Start heater and read air pressure value. If necessary adjust pressure to the correct value
read air pressure value. If necessary adjust pressure to the correct value turning the adjusting screw (the air vent hole in the
Compressor Pressure Adjustment (Fig. 6)
turning the adjusting screw (the air vent hole in the adjusting screw middle) clockwise to increase,
adjusting screw middle) clockwise to increase, anticlockwise to decrease the pressure:
anticlockwise to decrease the pressure:
The compressor pressure is factory set and must be checked and adjusted by qualified
Model Air pressure (bar)
technicians only. Tampering with the unit may be dangerous.
WD70
Remove pressure gauge cap. Connect a pressure gauge on the pressure measuring port on the rear
WD100
guard. Start heater and read air pressure value. If necessary adjust pressure to the correct value
WD170
turning the adjusting screw (the air vent hole in the adjusting screw middle) clockwise to increase,
anticlockwise to decrease the pressure:
Electrical
Inspect cables, electrical parts and connections.
Figure 6
Electrical
Inspect cables, electrical parts and connections.
Electrical
Inspect cables, electrical parts and connections.
Fig.3
Fig.3
0.32
0.31
0.45
M1.1.WD70-WD100-WD170.NLFREN - 25042019
Figure 5
Fig.5
Fig.5
Model
BGO1601-10
BGO1601-20
BGO1601-30
BGO1601-50
Fig.6
Model
BGO1601-10
BGO1601-20
BGO1601-30
BGO1601-50
Fig.6
24
Air Pressure (bar)
0.28
0.32
0.31
0.45
Air Pressure (bar)
0.28
0.32
0.31
0.45
EN