Cleaning, Maintenance And Storage - MW TOOLS WD70 Mode D'emploi

M1.1.WD70-WD100-WD170.NLFREN - 25042019
EN

6 Cleaning, maintenance and storage

Regularly wipe the enclosure using a soft sponge or cloth. For very dirty parts, use a sponge wetted with lukewarm water and a
mild detergent, then dry using a clean cloth.
Keep air inlet and fan free from dust and dirt. To clean inner parts, gently blow compressed air through air inlet.
Regularly inspect the power cable: if worn, cracked or damaged have it replaced by technical service.
Before storing the heater, make sure it is perfectly cool and dry. Cover the unit with a plastic bag, put it in its packing box and
store it in a dry, ventilated place.
WARNING!
• Before starting any maintenance task, shut down, unplug and let the heater cool down for at
least 15 minutes.
• Do not attempt any electrical repair yourself. If the heater needs service or repair, contact a
qualified technician.
• Do not use a faulty unit unless a qualified technician has inspected and repaired it.
• When cleaning, make sure that water does not enter the unit.
• Do not open the enclosure to clean the inner parts. Do not spray water into the heater.
• Never use solvents, gasoline, toluene and similar aggressive chemicals to clean the heater.
The following checks by qualified personnel only are recommended before every seasonal use:
Nozzle
Carefully unscrew nozzle from nozzle fitting. Blow compressed air through nozzle orifice to free it from dirt. Replace nozzle if
necessary.
Air Filters
Clean air filters. Remove filter end cover (11), wash air intake filter (10) using a light detergent and dry it thoroughly before
reinstalling. Replace air delivery filter (9) once a year (Figure 3).
Figure 3
Fig.4
Fig.3
23
Fig.5