Assembling Instructions - MW TOOLS WD70 Mode D'emploi

3 Assembling instructions

Extract the heater from its carton. If the unit is anyhow damaged, do not use it and contact your dealer.
WD70: The heater is only need to fix the plastic handle, no further operations required (see Figure 1).
Fig.1
Figure 1
WD100 -WD170: The following accessories are supplied in the shipping carton:
Figure 2
Fig.2
To assemble the heater, proceed as follows (see Figure 2):
1. Insert the wheel shaft J to the corresponding hole of feet pipe E, insert the cotter K to the corresponding holes. Put plain
corresponding holes; put plain washer I to the two sides of shaft, slide the wheel H over the wheel
washer I to the two sides of shaft, slide the wheel H over the wheel shaft J, screw the nut G to fix the wheel on the shaft.
shaft J，screw the nut G to fix the wheel on the shaft.
2. Put the heater body on the feet pipe assembly, make sure the 4 holes of handle A point towards the corresponding 4 holes
on the feet pipe respectively.
corresponding 4 holes on the feet pipe respectively.
3. Using the screws B, spring washers C, plain washers D and nuts to fix the feet pipe assembly and handle to the tank.
handle to the tank.
Position the heater on a flat, level, non-flammable, solid surface.
Direct-fired heaters are intended for use in outdoor open areas or in indoor well
ventilated areas. For indoor use, provide permanent ventilation openings of at least 25
cm²/kW, equally distributed between floor and high level, with a minimum of 250 cm².
Minimum Opening Size
built-in built-in
built-in built-in
Pos.
A
Pos. Description
B
A Screw
C
B Plain washer
C Handle
BGO1601-10 BGO1601-20
260 cm²
built-in
built-in
Description Qty
Screw
Quantity
Plain washer
2
Handle
2
1
Pos. Description
A Handle
B Screw
C Spring washer
Pos. Description
D Plain washer
A Handle
B Screw
E Feet pipe
C Spring washer
F Nut M5
D Plain washer
G Nut M12
E Feet pipe
F Nut M5
H Wheel
G Nut M12
I Plain washer Ø 12 mm
H Wheel
J Wheel shaft
I Plain washer ø12
K Cotter
J Wheel shaft
K Cotter
20
BGO1601-30
600 cm² 800 cm²
built-in
M1.1.WD70-WD100-WD170.NLFREN - 25042019
built-in
2
2
1
Quantity
1
6 ou 8
6 ou 8
Qty
6 ou 8
1
6or8
1
6or8
6 ou 8
6or8
2
1
6or8
2
2
2
2
1
2
2
1
2
BGO1601-50
1250 cm²
EN