Setting Up The Instrument - TESTO 108 Mode D'emploi

8. Setting up the instrument

In the set-up menu the unit, type of probe, and Auto-off -Time
can be changed.
The set-up menu must always be completely run through, also
if the only one parameter has been changed.
 Instrument is switched off.
1 Switching the instrument on:
- Display test appears.
2 hold pressed down for about 3 sec during Displaytest.
- Configuration mode is opened, after presetting °C or °F is
displayed.
3 Choose °C or °F unit:
- After presetting Type K or Type T is shown.
4 Choose probe type Type K or Type T:
with .
- After presetting 10, 30, 60 or off are displayed.
5 Auto-off Time 10, 30, 60 or off choose:
with .
- The configuration is finished. With the new settings, the
instrument changes in measurement mode.
8. Setting up the instrument 13
Press quickly.
press and confirm with
press and confirm
press and confirm
.