Service Department - nomadiQ CQ BBQ 002 Manuel D'instructions

5. After cleaning, the grilling shells can be placed back in the base by following above steps in reverse
order. To prevent damage, ensure that both guiding pins of the grilling shells are placed correctly in the
designated guiding slots in the base before sliding the shells into the base.
Cleaning and maintenance of the burner
It is strongly recomended to inspect and clean the burner tube at least once a year to keep your gas grill
performing safely and efficiently. To remove the burners for extensive cleaning and inspection, please
carefully follow the instructions below in combination with the reference visuals shown on page 9.
Also follow these steps if an irregular flame pattern is visible.
1. Ensure that the gas supply is closed and the gas grill is cooled down properly. Remove the 2 screws at the
center of the burner from the grilling shells, using a phillips type screwdriver and carefully slide the burner
out from the grilling shell. (Visual 32)
2. The information below should be taken into account during inspection and cleaning (Visual 33):
- From repeated use of the grill, the burner openings can become dirty over time. Dirty and blocked ports
can restrict the gas flow which can cause dangerous situations.
- Inspect the inside of the burner tube with a flashlight to determine if any obstuction is visible that will
restrict the gas flow to the burner openings.
If any obstruction is visible on the inside or outside, clean the area with a steel brittle brush or a steel wire.
Ensure that all blocked areas are clean before reinstalling the burner in the grilling shell.
For installing or replacing the burner, place the burner back in the grilling shell. Ensure that the tube is
placed properly over the gas opening and fasten the 2 screws.
Storage
When the appliance is not in use, the grill and the cylinder together must be stored outdoors in a well
ventilated area. However, it is permissible to store the appliance (but not the cylinder) indoors. Ensure the
appliance is cleaned well, especially the grates, before storing away. When the gas cartridge/canister is
disconnected, replace the plug or cap on the valve outlet if available.
Extended storage
After extended storage, it is recommended to clean and check the burner and gas supply, following the
instructions below.
Burners
Brush the outside of the burners with a stiff brush (i.e. toothbrush) to remove stains and dirt. Be careful not
to damage the igniter spark points.
Gas supply & connection
1. Inspect the gas hose assembly for any deterioration and replace it if necessary.
2. Test the gas circuit for leaks and repair if found. Also see 'leak detection procedure' in the 'Gas
connections & regulator' section of this manual.
3. Check if the seals of the gas hose assembly (between the appliance and the gas cartridge/canister) are
in place and in good condition. Also, check before connecting a new gas cartridge/canister. These seals are
located in the quick-connectors and gas regulator. The exact location can be found following the visuals on
page 13. If it seems the seals need replacement, contact our Service Department for further advice.

7. Service Department

Contact details
nomadiQ Grills Customer Service
1-855-474-5524 or 1-855-GRILL2GO
E-mail: support@nomadiqgrills.com
Or fill out the online contact form: www.nomadiqgrills.com
8. Warranty
This is nomadiQ's Warranty provided to you at no extra charge. It contains the information you will need to
have your product repaired in the unlikely event of a failure or defect.
16