Techly I-ALARM-KIT002 Manuel D'installation page 52

Change user code
The user code may be required to interact with the control panel (arm or disarm
the system, or switch to Home Mode). We recommended you to change the user
code before using the keypad for the first time.
1. Enter Setup mode.
2. Type [38+new user
3. You head one beep: the setup is
successful.
Remark
The user code must consist of 4 digits. Default user code is "1234".
Change admin code
The admin code nay be required to change the settings and interact with the
control panel (arnm or disarm or switch to Home Mode). We recommend you to
change the admin code before using the keypad for the first time.
1. Enter Setup mode.
2. Type [39+new admin
3. You head one beep: the setup is
successful.
Remark
The admin code must consist of 6 digits. Default admin code is "123456".
52
code+#].
code+#].