Techly I-ALARM-KIT002 Manuel D'installation page 49

If the exit delay has been set, the control panel will beep once every seconf after
having pressed the Arm ( ) key. The rythm of the beels will speed up during the
last 15 seconds. After the exit delay time has elapsed, the control panel is armed.
If the exit delay has been set up for both the control panel and the keypad, the
actual delay time will be the combination of both exit delays.
This setting does not apply to the Home Mode.
Remark
Only the Exit Delay can be set on the keypad. The Entry Delay can be set on the
control panel (refer to the user manual of your alarm system).
Lock/Unlock the SOS button
Lock the SOS button
1. Enter Setup Mode.
2. Type [3410#].
3. You hear one beep: the setup is
successful.
If the SOS button is locked, you will
need to press Arm ( ) or Home Mode
( ) to unlock the keypad, to type your
admin or user code, then to press [SOS]
to trigger the alarm.
Unlock the SOS button
1. Enter Setup Mode.
2. Type [3411#].
3. You hear one beep: the setup is
successful.
If the SOS button is unlocked, the
control panel will ring out immediately
when you press Arm ( ) or Home Mode
( ) and then [SOS].
Remark
Defaulf setting: SOS button is locked.
www.techly.com 49