Abicor Binzel ABIROB W50 Fiche D'instruction page 7

ABIROB W50
5 Adjusting the welding torch
To prevent damage to the welding torch, the welding torch must first be coarse adjusted and then fine
adjusted again.
Coarse adjustment
Fine adjustment
5 Adjusting the welding torch
Close the clamp on the locating block.
1
Tighten the 2 cylinder head screws M8 × 50 with
2
an AF5 Allen key and max. torque of 8 Nm.
Insert the test mandrel into the gaging sleeve.
3
If the test mandrel does not fit smoothly into
4
the gaging sleeve, push the lever over the setting
sleeve and coarse-adjust the welding torch by
pulling the lever.
Loosen and remove the 2 cylinder head screws
1
M6 × 50 with the AF5 Allen key.
Remove both parts of the clamp from the
2
locating block.
EN - 4