Homelite UT43123 Manuel D'utilisation page 25

in the direction of chain rotation. If they face
backwards, turn the loop over.
 Place the chain drive links into the bar groove as
shown.
NOTE: Make certain of direction of chain.
 Position the chain so there is a loop at the back
of the bar.
 Hold the chain in position on the bar and place
the loop around the sprocket.
 Fit the bar flush against the mounting surface so
that the bar studs are in the long slot of the bar.
CUTTERS CHAIN ROTATION
CHAIN DRIVE LINKS
CHAIN DRIVE LINKS
MAINTENANCE
When placing the bar on the bar studs, ensure
that the chain tensioning pin is in the chain ten-
sion pin hole. Failure to properly place the chain
tensioning pin in the chain tensioning pin hole
could cause the chain to come loose, resulting
in serious personal injury.
 Replace the chain cover.
CHAIN TENSIONING
Fig. 27
BAR GROOVE
CHAIN TENSIONING
Fig. 28
Page 25 — English
WARNING:
PIN HOLE
BAR STUDS
KNOB
CHAIN COVER
LOCK KNOB
Fig. 29
Fig. 30