Beaba ZEN PREMIUM Notice D'utilisation page 31

XII. TROUBLESHOOTING - FAQ
Problems
If the signal is not stable:
(loss of signal)
The image lmed by the
camera is not displayed on
the receiver's screen
Unable to nd the pairing
button
What to do if the screen is
blocked and does not work
when you press a button?
Why is the camera or the
screen unable to identify
the SD* card?
Why am I unable to receive
noti cations with my mobile
phone app when I connect
the camera to the screen?
Possible causes
Interferences disturb the signal
or the receiver is too far from
the camera
Check that the receiver is
connected to the camera.
The pairing button is the
button on the front part of the
camera.
You must reset your display
screen.
Check that the SD* card is
inserted correctly
Noti cations are probably
deactivated on the phone.
31
Solutions
Move the camera and receivers
away from devices operating in Wi
that may interfere with the signal /
use the application to access the
camera from the smartphone
If this is not the case, start by pairing
the camera and the receiver.
Press and hold the button for 3
seconds, then follow the instructions
on the screen. (To access the
screen's pairing screen, press
the Menu button on the display
> Manage
screen and select
cameras.
Press the reset button on your
screen with a pin, then press and
hold the power button on your
screen to restart it.
The format must be FAT32
Please check that the app is
running on the phone and that the
corresponding noti cations have
been activated.