Table des Matières
Publicité
4. If the battery pack does not charge properly:
a. Check operation of receptacle by plugging in a lamp or other
appliance;
b. Check to see if receptacle is connected to a light switch which
turns power off when you turn out the lights;
c. Move the charger and battery pack to a location where the
surrounding air temperature is approximately 65 °F – 75 °F
(18° – 24 °C);
d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
5. The battery pack should be recharged when it fails to produce
suffi cient power on jobs which were easily done previously. DO
NOT CONTINUE to use under these conditions. Follow the
charging procedure. You may also charge a partially used pack
whenever you desire with no adverse effect on the battery pack.
6. Foreign materials of a conductive nature such as, but not limited
to, grinding dust, metal chips, steel wool, aluminum foil, or any
buildup of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply when
there is no battery pack in the cavity. Unplug the charger before
attempting to clean.
7. Do not freeze or immerse the charger in water or any other liquid.
WARNING: Shock hazard. Don't allow any liquid to get inside the
charger. Electric shock may result.
WARNING: Burn hazard. Do not submerge the battery pack in any
liquid or allow any liquid to enter the battery pack. Never attempt to
open the battery pack for any reason. If the plastic housing of the
battery pack breaks or cracks, return to a service center for recycling.
Storage Recommendations
1. The best storage place is one that is cool and dry, away from
direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool dry place out of the charger for optimal
results.
NOTE: Battery packs should not be stored completely depleted of
charge. The battery pack will need to be recharged before use.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
COMPONENTS (Fig. 2, 5)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
FIGURE 2
A. Variable speed trigger switch
B. Lock-off button
C. Handle
D. LED worklight
E. LED worklight button
F. Top cap
G. Flexible hose
H. Flexible hose safety spring guard V. Filter
I. Flexible hose coupler
J. Grease tube
K. Grease tube cap
L. Grease tube handle
M. Grease tube rod
N. Grease tube assembly
9
O. Retaining slot
P. Battery
Q. Battery release button
R. Rubber feet
S. Hose clip
T. Shoulder strap mount
U. Shoulder strap clip holes
FIGURE 5
W. Pressure relief valve
X Purge valve
Y. Check valve
Z. 1/8" NPT fill port
AA. 1/8" NPT fill port plug
Publicité
Table des Matières
