Publicité
Les langues disponibles
Les langues disponibles
-
Set the audio output of any audio processor between the mixer and the amplifier(s) to a
medium level (if any such processors)
-
Turn up the volume controls of your amplifier(s) slowly
-
Make adjustments to all volume settings as needed
For switching off, follow the inverse sequence – always switch off your amplifier(s) first, then any
processors between mixer and amplifier(s), then the mixer, then the sources.
C.
FIRST USE
To get familiar with the DMP230, prepare a solid state media of 16GB or less memory size, formatted in
FAT32, and loaded with the following content:
-
A number of folders which are generated on the media in the sequence they are supposed to
be listed on the unit later, with folder names not longer than 10 digits
-
MP3 files stored in each folder with file names possibly no longer than 30 digits and sufficient
differences in the first 8 digits if concise sorting is required
-
A specific folder named "Jingles" with up to three jingle flies inside named "j1_01.mp3',
"j2_02.mp3" and "j3_03.mp3".
Put the DMP230 into operation by powering it up via the power switch (7). Choose the desired operation
mode (FM or Media play) via the button (18). If you select Media play, the unit will show "No Media".
Insert the prepared solid state media, and the DMP230 will show "READ" and count down while loading
the file directory structure. Once done, the available folders will be shown for selection. Select the
desired folder via the dial (11) and confirm by pressing the dial; the DMP230 will now show the MP3
files available in the chosen folder. Scroll with the dial (11) and confirm by pressing the dial and the
chosen MP3 track will start to play. Replay can be paused or stopped via the button (13), and the play
mode and play sequence can be set by the buttons (14 / 15). The time display can be set to remaining
or elapsed via button (16). You can choose the next song according to the selected play sequence by
the dial (11), simply turn for scrolling and press for confirmation. To change the folder, press the folder
level button (12) and the DMP230 will show the folder directory; turn the dial (11) to scroll for choices
and press the dial to choose a new folder. Inside the folder, the track selection follows the above
description.
To change to FM mode, press the source selection button (18). The unit will change to FM reception
and you will show either the current tuning frequency or the current station preset. To change between
station preset display and tuning frequency display, press the dial (11) once. Turning the dial then either
tunes to a new frequency of changes the station preset in a sequential manner. Store a new station
preset by selecting the tuning frequency display via pressing (11), then tune to the frequency to be
stored, then press the FolderLevel / Store button (12) and select the preset number to be stored by
scrolling the dial (11). Press the FolderLevel / Store button (12) again to confirm storage. The newly
stored preset is now available. Note that the FM tuner will show the station name instead of a frequency
if the station broadcast a RDS PS data set; only PS (station name) data will be displayed, all other RDS
data will be ignored.
To insert a jingle on-the-spot into the running program material (regardless of whether Media play or FM
mode), simply press one of the three jingle buttons end the corresponding jingle in the JINGLES folder
will be played immediately and once, while the program progresses in the background. To activate
scheduled jingle replay, press the J1 (jingle 1) button longer than 2 seconds, until the LED (20) is lit. The
Publicité
