Frigidaire FFRE1001PW Manuel D'installation page 16

INSTALLATION INSTRUCTIONS
General installation
1 Connect the exhaust duct to the outside exhaust
system. Use of a 4" (102 mm) clamp (item A) is
recommended to connect the dryer to the exhaust
vent system. Use metal foil tape to seal all other
joints.
2 Use a carpenter's level to level your dryer front-to-
back and side-to-side.
3 Use adjustable pliers to adjust the leveling legs so
the dryer is level front-to-rear and side-to-side, and
stable corner-to-corner.
4 Press down on alternate corners and sides and feel
for the slightest movement. Adjust the appropriate
leg(s) so the dryer sits solidly on the fl oor on ALL
four legs. Keep the leveling leg extension at a
minimum for best performance of the dryer.
IMPORTANT
Be sure the power is off at a circuit breaker/fuse box
before plugging the power cord into an outlet.
5 Plug the power cord into a grounded outlet.
Grounding type Grounding type
wa wall receptacl ll receptacle
Do not, under Do not, under
an any cir y circumstances, cumstances,
cut, cut, remo remove ve,
or b or bypass th ypass the
gr grounding pr ounding prong.
Po Power cord with wer cord with
3-prong 3-prong gr grounded plug ounded plug
6 Turn on the power at the circuit breaker/fuse box.
7 Read the Use & Care Guide provided with the dryer.
It contains valuable and helpful information that
will save you time and money.
8 If you have any questions during initial operation,
please review the "Avoid Service Checklist" in your
Use & Care Guide before calling for service.
9 Place these instructions in a location near the dryer
for future reference.
NOTE
A wiring diagram and technical data sheet are located
under the dryer top panel.
16
ong.
A
a
c
b
lower
raise
d