Pendant Functions And Use - Chattanooga Group OptiFlex3 2090 Manuel D'utilisation

NOMENCLATURE

PENDANT FUNCTIONS AND USE

All user input and feedback is provided through the pendant. The following
are descriptions of each button provided with OptiFlex ® 3.
Extension: View and modify the extension angle
parameter.
How to use: To view the extension angle, press and hold
the Extension button. To modify the current extension
angle, press and hold the Extension button while pressing
either the Up or Down Arrow.
Flexion: View and modify the flexion angle parameter.
How to use: To view the flexion angle, press and hold the
Flexion button. To modify the current flexion angle, press
and hold the Flexion button while pressing either the Up
or Down Arrow.
Speed: View and modify the speed parameter.
How to use: To view the speed, press and hold the Speed
button. To modify the current speed, press and hold the
Speed button while pressing either the Up or Down
Arrow.
Extension/Flexion Delay: View and modify the delay
time for the extension or flexion angles. Using Extension/
Flexion Delay will cause the carriage to stop at the
extension and flexion angle for the time programmed.
OptiFlex® 3 Continuous Passive Motion (CPM) Therapy Unit
How to use: To view the extension/flexion delay time, press
and hold the Extension/Flexion Delay button. You can
set independent Delay times for extension and flexion. If
an extension and or flexion delay time is required, simply
hold down the Delay button and the Extension or Flexion
button and use the Up or Down Arrows to adjust the time.
Up Arrow: Increases treatment parameters in conjunction
with other buttons.
How to use: Select the specific function to increase (Speed,
Extension, Flexion or Extension/Flexion Delay). While
pressing and holding the appropriate button, use the Up
Arrow to increase the value of the specified function.
Down Arrow: Decreases treatment parameters in
conjunction with other buttons.
How to use: Select the specific function to decrease
(Speed, Extension, Flexion or Extension/Flexion Delay).
While pressing and holding the appropriate button, use
the Down Arrow to decrease the value of the specified
function.
Reset: Resets all parameter and patient counters to
factory defaults.
How to Use: To reset patient compliance counters, press
and hold lightly by inserting a paper clip and accept reset
by pressing the Mode button. To display total unit run
time and cycles, press and hold Reset for 3 seconds, the
total unit time and cycles are temporarily displayed.
7