Publicité
Les langues disponibles
Les langues disponibles
3.2.7 Use of a safety temperature limiter
N
L
N
L TB
N L
Connection of a customer-supplied safety temperature limiter (1). This device switches off the pump
and sets the input to TL if too high flow temperatures for the floor heating are detected. If the TL
input is switched, the base station shuts down all actuators automatically.
3.2.8 Connection of Ethernet variants
The base stations are equipped with a RJ45 interface and an integrated web server for the control
and the configuration of the system via PC/laptop and over the Internet.
¾ Integration of the base station into the network via network cable, or direct connection to
PV/laptop
Set-up in the home network
¾ Open the router menu (see manual of the respective device) via the address bar in the web
browser (Internet Explorer, Firefox, ...).
¾ Open an overview of all devices in the network.
¾ Compare to the MAC address (see type sign) in order to find out the IP address allocated to
the base station.
¾ Note the IP address of the base station and enter it into the address bar of the web browser
in order to open the web interface.
Direct connection to PC/laptop:
¾ Open the network settings in the PC/laptop and assign the IP address 192.168.100.1 as
well as the subnet mask 255.255.0.0 manually to the PC.
¾ Access to the web interface can be gained by entering the IP address 192.168.100.100 in
the address bar of your web browser.
You can find further information on the set-up as well on worldwide access via the Internet under
www.ezr-home.de.
230 V
pump
boiler
ECO
CO
H %
1
2
1
2
1
2
1
2
1
2
1
HZ 1
HZ 2
HZ 3
HZ 4
1
2
1
2
1
2
1
2
1
2
1
HZ 5
2
1
2
1
2
DEU
ENG
FRA
NDL
ITA
ESP
31
Publicité
