Kalorik PCM 43848 Mode D'emploi page 3

IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be
followed, including the following:
1. READ ALL INSTRUCTIONS BEFORE USE
2. Check that the voltage in your home corresponds to that stated on the
rating plate of the appliance before using the appliance.
3. Do not leave unattended while in use. Always unplug the product from
the electrical outlet when not in use.
4. Never plug in or operate the unit when empty, or when not fully
assembled.
5. DO NOT TOUCH Hot surfaces. This product will become hot when in use.
Use protective hand covering (oven mitts) to avoid burns or serious
personal injury.
6. To protect against electrical shock do not immerse cord, plug, or the
motor unit in water or other liquid.
7. Close supervision is necessary when the appliance is used by or near
children.
8. This product is not a toy! Please keep out of reach of children and pets.
This product is not intended for use by children, by persons with reduced
physical, sensory or mental capabilities, or lacking experience or
knowledge, unless they have been given supervision or instruction
concerning the use of the product, by a person responsible for their
safety. Extra caution is always necessary when using this product.
9. The cover must be in place before plugging the product into an electric
outlet.
10. Never put more than 1 measuring cap (2.8 oz. / 80g) of kernel into the
popping chamber, else kennels will not pop and the machine could be
damaged.
11. Do not move the product when in operation or heated.
12. Unplug from outlet when not in use and allow cooling before putting on
or taking off parts, relocating, servicing or before cleaning.
13. Occasionally, un-popped kernels may be thrown out from the chute. Do
not pick up the hot kernels immediately! To avoid contact with the hot
kernels, never put your face, hands, or other body parts near the product
while in operation. Keep at least 3 feet (1 meter) away from the product
when corn is popping.
14. Do not put on a glass surface. And always place the product on a flat,
level, stable and heat resistant surface, especially during operation.
www.KALORIK.com
3
PCM 43848 - 170120