Publicité
Les langues disponibles
Les langues disponibles
Keep out of direct sunlight & make sure the sensor is well ventilated.
3. OPERATION
•
After connecting the main unit to the power (or installing the batteries), the unit is
automatically turned ON. The main unit will start to detect indoor temperature / humidity.
To receive signals from the remote sensor, both devices should be set to same channel.
•
For example, if you have chosen channel 2 for the sensor, you should select channel 2 for
the main unit as well. Select the desired channel for the main unit using the [CHANNEL]
button at the back of the unit.
When you have set both the weather station and the outdoor sensor to the same channel,
•
you should keep the [CHANNEL] button pressed until you hear a beep and the 3 dashes
on the display start to flash. The outdoor sensor and the weather station will now connect
to each other, this can take up to 3 minutes.
•
After connecting the main unit to the power (or installing the batteries), the unit is
automatically turned ON. The main unit will start to detect indoor temperature / humidity.
•
If no signal is received within 3 minutes, the receiving antenna signal will stop. Automatic
signal re-synchronization will be activated the next hour until the signal is received and
outdoor sensor data is displayed on the main unit.
Remarks:
• The weather station supports a connection with up to 3 sensors. Make sure each sensor is
assigned to a different channel number. In standard mode, press the [CHANNEL] button to
switch between the information of the 3 channels.
• The distance between main unit and transmitter should be at least 1.5~2 meters, away from
any interfering sources such as computer monitors or TV sets. The main unit cannot stand
close to metal window frames. Please do not use other electrical products such as
headphones or speakers operating on the same signal frequency.
BUTTONS
[SET]
Press and hold to enter Setting mode
Press to enter the following settings: time / date / barometric pressure format
/ language / 12/24h format / beep
Press to confirm a setting
[▲ / MEM] Press to view daily max. / min. temperature & humidity record
Press and hold to delete daily max. / min. temperature & humidity record
In setting mode, press to change the setting item to the desired values
[▼ / CF]
Press to select temperature format °C/F
Publicité
