GUARDO WS-300 Mode D'emploi page 3

1. LED light
2. Battery compartment
3. Hanging hole
4. Channel shift
5. Rope hanging hole
2. INSTALLATION
MAIN UNIT
1. Remove the protection foil from the display.
2. Remove the battery compartment cover (22).
3. Insert 3 x AAA batteries matching the correct polarity (+and-) (optional, for use
without DC adapter).
4. Take out the metal stands in the battery compartment, assemble them to the metal
stand holes (24).
5. Connect the adapter with the main unit (23) and a power outlet.
6. Close the battery compartment cover.
The main unit can be placed on a horizontal surface using the metal stands (24) or it can be
hung on a wall using the hanging hole (20).
SENSOR
1. Remove the battery compartment cover, chose the channel (1,2,3) using the channel
switch (4).
2. Insert 2 x AA batteries matching the correct polarity (+ and -). The red led light (1) will
flash once.
3. Close the battery compartment cover.
The sensor can be hung on a wall using the hanging hole (3).
Remarks:
Mount your sensor on a north-facing wall or in any shaded area. Under an eave or
•
deck rail is preferred.
The maximum wireless transmission range to the weather station is up to 50 meters
•
in open air, not including walls or floors.
Mount your sensor in a horizontal position, to allow moisture to drain out properly.
•