Briteq LDP-GARDENSPOT 4TC Mode D'emploi page 5

ENGLISH
DESCRIPTION:
1. FIXING HOLES: can be used to fix the projector to the ground,
wall or ceiling. Use adapted, non corroding, screws or bolts for
this.
2. MAINS INPUT: connect this power to the mains. If the projector
is used outside you MUST use a waterproof junction box. (our
"LDP-JUNCTION IP68" (order code: 5112) is perfect for this!)
3. DMX OUTPUT: this cable is used for DMX512 linking to the
next projector in the chain. Use good quality DMX-cable to
assure stable performance. If the projector is used outside you
MUST use a waterproof junction box. (our
(order code: 5112) is perfect for this!)
4. DMX INPUT: this cable is used for DMX512 linking coming from
a DMX-controller or from the previous projector in the chain.
Use good quality DMX-cable to assure stable performance. If
the projector is used outside you MUST use a waterproof
junction box. (our
perfect for this!)
5. TEMPERED GLASS: protection for the LEDs, make sure to
replace the glass while broken!
6. BRACKET: with 2 bolds on both sides to fasten the unit in the
desired vertical position.
7. LEDs: 4pcs RGB 3-color 3watt LEDs.
8. BRACKET BASE: with 2 bolds to fasten the unit in the desired
horizontal position.
9. ALUMINIUM BASE: contains all electronics and power supply.
OVERHEAD RIGGING
 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
BRITEQ
®
"LDP-JUNCTION IP68" (order code: 5112) is
(IF APPLICABLE)
"LDP-JUNCTION IP68"
3/44
USER MANUAL
LDP-GARDENSPOT 4TC