Hilti SD 5000-A22 Mode D'emploi page 23

3.4 Items supplied
Drywall screwdriver, depth gauge, bit holder, bit, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group.
3.5 Overloading and overheating protection
The drywall screwdriver is protected from overloading and overheating by an automatic cut-out. Overloading
or overheating is indicated by the four LEDs blinking. After overheating, when the control switch is pressed
to restart the screwdriver, there may be a delay before the screwdriver restarts.
4 Technical data
4.1 Screwdriver
Rated voltage
Weight in accordance with EPTA procedure 01/2003
Rated speed under no load
Maximum torque
Socket/bit drive
Screw length
Screw diameter
Operating temperature
Storage temperature range (without battery)
4.2 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.3 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Sound (power) level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Vibration emission value, screwdriving without hammer action (a
Uncertainty for screwdriving (K)
*400171*
)
WA
)
WA
)
pA
)
pA
400171
21.6 V
2.7 kg
0 /min ... 5,000 /min
9.5 Nm
Hex socket
≤ 55 mm
≤ 4.2 mm
−10 ℃ ... 50 ℃
−30 ℃ ... 70 ℃
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
82 dB(A)
3 dB(A)
71 dB(A)
3 dB(A)
) 1 m/s²
h
1.5 m/s²
English
/ "
1
4
17