▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3
Description
3.1
Overview of the product
3.2
Intended use
The product described is a hand-held cordless electric tool, equipped with a clutch, for use in drywall
installation work.
The power tool is designed for driving and removing screws in drywall installation work. Drywall screws with
a length of up to 55 mm and a diameter of up to 4.2 mm can be used.
Do not use the product to work with materials hazardous to the health (e.g. asbestos)
▶ Use only Hilti Liion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3
Charge state display
The charge state of the Liion battery is displayed after pressing one of the release buttons lightly (press only
until slight resistance is felt).
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
16
English
1
@
;
=
%
&
(
)
+
§
/
:
∙
$
Meaning
Charge state: 75 % to 100 %
Charge state: 50 % to 75 %
Charge state: 25 % to 50 %
Charge state: 10 % to 25 %
Charge state: < 10 %
Chuck
Power tool / accessory interface (snap-on
connection)
Universal hook
Motor cooling air intake
Grip
Motor cooling air intake
Forward / reverse selector switch with safety
lock
Control switch (with electronic speed control)
Lockbutton for continuous operation
Belt hook
Charge-status and fault indicator (Li-ion bat-
tery)
Battery release buttons
Depth gauge
400171
*400171*