Warn 91270 Instructions D'installation page 4

1. Remove factory bumper.
2. Place winch mount (A1) into position. Install fasteners (B1
and B2) into side location.
Note: The plastic grill was removed for clarity. It is not
necessary to remove the plastic grill to install winch
mount.
3. Place backing plate (A2) into position behind cross member.
4. Install fasteners (B1 and B2). Leave fasteners loose to
allow winch mount to be adjusted.
©2013 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
I N S T A L L A T I O N I N S T R U C T I O N S I N S T A L L A T I O N I N S T R U C T I O N S
4
Bumper
Figure 1
B1 & B2
Winch Mount
Figure 2
B1 and B2
Figure 3
91271A0