Amann Girrbach ap100 Mode D'emploi page 8

gB
MFITTIng The BlOCkOuT seT
(ap100 BlOCkOuT seT)
Plug the adapter cable plug into the back of the
base. Then insert the cylindrical section (bush)
of the adapter cable into the opening
hinged arm and tighten it with the screw
the adapter cable to the pillar with the cable
holder. Insert the Blockout holder into the
surveying head and tighten it with the knurled
nut . Finally, insert the Blockout holder plug
&
into the adapter cable socket from beneath. The
Blockout set can be controlled progressively
with the knob
BM
ap100 (FITTIng The MIllIng heaD)
Grip the surveying head and loosen the screw
to remove it. Insert the milling head into the
opening in the hinged arm from beneath and
tighten it with the screw
InserTIng a hanDpIeCe InTO The
MIllIng heaD
Press the correct handpiece adapter sleeve onto
the handpiece from the back. Then insert both
into the opening in the milling head and tighten
them with the screw
serVICIng
These units do not require servicing. Should they
become dirty, keep them dry when cleaning.
CauTIOn! Do not steam-clean or use solvents
for cleaning!
8
*
on the base.
.
^
.
BP
Technical Data:
D/B/H:
Weight:
Chuck range:
in the Power supply:
. Fix Power uptake:
(
Fuse:
packing list:
Order No.:
177700
accessories/ Individual parts:
^
Order No.:
177960
177450
177071
873001
!
WarnIng anD saFeTy
InsTruCTIOns:
The unit described in this manual was develo-
ped for dental applications. It must be installed
and operated as described in the user's manual.
The manufacturer is not liable for damage
caused by handling the equipment incorrectly.
In addition, if the intended application is not
listed in the user's manual, the user is obliged
to check personally in advance that the unit is
suitable for this purpose.
!
CauTIOn - rIsk OF Injury:
_ D o not steam-clean or clean with solvents.
_ I f the ap100 Blockout set is fitted, there is
a risk of burning if the Blockout set is used
at full power.
210 x 180 x 400 mm
6,2 kg
1 – 3 mm
230 V – 50 Hz
22 W
1A time-lag
AP100 unit including
P Hinged arm
Surveying head
User's manual
Guarantee
AP100 Block-out set
Halogen lamp
(for theAP100)
Milling head
(for the AP100)
Starter kit - Milling