KIRAMI MS-250 Mode D'emploi page 23

© Kirami Oy, Finland
Safety information
1. All electric installations shall be carried out by qualified authorized persons. The device
shall always be connected to RCD protected power socket. The system and RCD must be
tested before every use.
2. The mass filter is designed to work with water at temperature>than 4℃ and <than
40℃.The filter should never be operated outside of these temperatures or damage may
occur.
3. The installation should be carried out in accordance to the safety instructions of used pool /
hot tub and the specific instructions for each facility.
4. The user should make sure that the installation is carried out by qualified authorized
persons and that these persons have first carefully read the following instructions.
Incorrectly installed equipment may fail, causing severe injury or property damage.
5. Before installation please check the delivery of the equipment and condition of all parts.
The warranty does not cover parts broken during installation.
6. The operating safety of the filter is only guaranteed if the installation and operation
instructions are correctly followed.
7. To reduce the risk of injury, do not permit children to use this product.
8. The system shall be protected against freezing and overflow water with e.g. insulated
filter housing that has good draining. During summertime the housing must have good
ventilation so that the temperature does not rise over 40℃. During wintertime the housing
must be heated (e.g. frost guard heater), so that the system will not freeze. High
temperatures and freezing can damage the system. We recommend you, to empty the
system and move it to warm storage for winter.
9. Chemical spills and fumes can weaken Swimming Pool/ Hot tub. Corrosion can cause filters
and other equipment to fail, resulting in severe injury or property damage. Do not store
pool chemicals near your equipment.
10. Do not move water filled filter system, so you do not break it. Never lift the system from
hose or handle on the top valve.
11. Any modification of the filter requires the prior consent from the supplier's original
replacement parts and accessories authorized by the manufacturer ensure a high level of
safety. The supplier assumes no liability for the damage and injuries caused by
unauthorized replacement parts and accessories.
12. In the event of defective operation or fault, contact the supplier or its nearest authorized
service agent.
13. We reserve all rights to make changes to the product without prior notice.
14. The product is meant only for private outdoor usage with hot tubs and small pools.
WARNING! To prevent electrocution:
Always connect the device to RCD protected power socket.
Check the power cords, and no not use the product if the cord is damaged. Replace damaged
cord immediately.
No not use extension cords when connecting the product to outlet. Use properly located
grounded outlet.
Do Not Touch Plug with Wet Hands.
Manual: Mass filter MF-250
02.12.2020
23 / 68