tomado TDW5501W Mode D'emploi page 36

Cleaning the dishwasher regularly, prolongs the dishwasher's service life.
Check before cleaning the dishwasher if it's is turned off. Unplug the dishwasher and turn off the tap.
Clean the outside of the dishwasher with a damp cloth. To prevent odors from forming within the dishwasher, clean the seals of
the door regularly with a soft damp cloth.
To prevent the dishwasher from getting clogged, we advise to clean the dishwasher regularly with a special cleanser.
Fill the detergent reservoir with detergant, select a cycle with a high temperature and start the program. If this is insufficient,
use a special cleanser for dishwasher and follow the instructions on the packaging.
Clean the filters and the spray arm once a week.
CLEANING THE FILTERS
Check once a week if there is any residue on the filters. Remove the filters and clean them thoroughly under the water tap.
The filter system consist of three components:
• sieve (A)
• filter - fine (B)
• filter - coarse (C)
Open
C
B
A
C
B
A
• Do not use the dishwasher when there are no filters in place.
• Incorrect fitting of one the filters will result in the dishwasher no longer delivering maximum performance.
• Make sure the filters are clean. This ensures proper functioning of the dishwasher.
CLEANING THE SPRAY ARM
Check the nozzles of the spray arm regularly for waste. Waste can block the nozzles and bearing in the spray arm. Remove the
clogging in the spray arm and clean them with warm water.
• Remove the spray arm by pulling it upwards.
• Clean the spray arm with warm water.
• Make sure the spray arm is perfectly locked when refitting the spray arm.
CLEANING AND MAINTENANCE
C
B
A
1. To remove the filters, turn the filter (B) anti-clockwise
2. Pull it (B and C) upwards.
3. Pull the coarse filter (C) from the fine filter (B) and clean both parts with warm water
using a dishwashing brush.
4. Take the sieve (A) out of the dishwasher and clean it with warm water and if needed a
dishwashing brush. Place the sieve back in the dishwasher.
5. Place the coarse filter in the fine filter with the markings allined. Re-fit the filters in the
sieve and turn it clockwise to fixe it.
EN - 36