Publicité
Les langues disponibles
Les langues disponibles
should be fitted inbetween.
After the connections are made, the tap should be turned
on fully and checked for water leakage.
• The water drain hose can be connected either directly to
a drain pipe with a minimum diameter of 4 cm, or let it run
into the sink, making sure to avoid bending or crimping it.
The free end of the hose must be at a height between 40
and 100 cm and must not be immersed in water.
• Close the water tap after each use.
Warning: When a drain hose longer than 4 m is used,
the dishes might remain dirty. In that case Tomado will not
accept responsibility.
ELECTRICAL CONNECTION
The plug of the appliance must be connected to an
earthed socket. Make sure that the voltage and the
frequency values for the current in the home correspond to
those on the rating plate. Tomado is not responsible for
damage when using the appliance with a socket that is not
earthed.
The electrical installation in the home must be provided
with a fuse of 16 Amp. The dishwasher is designed for
connection to 220 -240 V ~50 Hz. The appliance should not
be plugged in during positioning.
Always use the coated plug supplied with your machine.
• The appliance's electrical cable should only be replaced by
an authorised service or an authorised electrician. Failure to
do so may lead to accidents.
• For safety purposes, always make sure to disconnect the
plug when a wash program has finished. In order not to
cause an electric shock, do not unplug when your hands are
wet.
EN - 25
Publicité
