Atlas Copco EBL35 Mode D'emploi page 7

EBL35
Torque range
(Nm)
0.04 - 0.1 *
0.08 - 0.2
0.2 - 0.6
Test joints - Soft joints
1/4" female hex connection
Torque range
(Nm)
0.04 - 0.1
0.08 - 0.2
0.2 - 0.6
0.6 - 2.0
1.5 - 4.0
3.0 - 7.0
In-line torque transducers - Torque/angle models
Model Drive Hex inch
IRTT 1A-I06 ½
IRTT 2A-I06 ½
IRTT 5A-I06 ¼
IRTT 5A-06
Operating instructions
Fuses
The EBL Drive and EBL RE-Drive have a built-in PTC protection. To reset disconnect the mains plug for 10
seconds.
Attaching the bit
T Make sure you disconnect the tool from the power source before replacing the tool bit, especially
when using a push start type tool. Replacing the bit while the tool is connected to a power source
may cause injury when the bit begins to rotate.
General
The screwdriver is designed to work with the EBL drive or EBL RE-Drive as power unit.
Start options
The EBL screwdriver is equipped with options for lever start and push start. With lever start the tool starts by
pulling the black lever on the machine. With push start the tool starts by pushing the bit towards the screw and
work piece. Start mode is easily reconfigured by changing the switch position under the lever of the tool.
Test joint
Ordering No.
4145 0958 71
4145 0958 73
4145 0958 74
Test joint
Ordering No.
4145 0958 76
4145 0958 77
4145 0958 78
4145 0959 80
4145 0959 81
4145 0959 82
Drive Square inch
¼
© Atlas Copco Industrial Technique AB - 9836 8205 00
EN
Screw size
M2x16
M2x16
M3x20
Screw size Screw quality
M2x16 12.9
M3x20 12.9
M3x20 12.9
M4x30 12.9
M6x35 12.9
M6x35 12.9
Rated capacity Nm
1
2
5
5
Spare screw
Screw quality Ordering No.
12.9 0211 1965 45
12.9 0211 1965 45
12.9 0211 1110 00
Spare screw
Ordering No.
buy locally
buy locally
buy locally
0211 1177 00
0211 1251 00
0211 1251 00
ft lb
0.8
1.5
4
4
Operation
Ordering No
8092 1130 96
8092 1182 01
8092 1182 06
8092 1182 08
7