CAUTION:
This device is not intended to be immersed in water during cleaning.
• Please observe the instructions that we have included for you in the
chapter "Cleaning".
Commissioning
•
Remove all packaging materials.
•
Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
•
Connect the appliance to a properly installed earthed
socket.
•
Slide the switch on the handle to the position "I" to turn on
the appliance. The control lamp lights. The appliance will
be operational after a few minutes.
NOTE:
When the appliance has heated up, it may result in a slight
development of odors. This odor is caused by the coating of
the heating rod and will disappear with time. Ensure sufficient
ventilation.
Use
WARNING:
•
Only use the appliance for dry hair.
•
Do not touch the scalp with the hot curling tongs.
CAUTION:
•
Only use the appliance with natural hair. It is not suitable
for artificial hair pieces or wigs due to its high tempera-
ture.
•
Never use the appliance in combination with styling prod-
ucts such as mousse, hairspray, or gel.
TIPS:
•
We recommend that you spray heat protection spray
onto your dry hair prior to the application.
•
You will achieve tightly rolled curls with thin strands of
hair (ca. 2 cm). Take thicker strands (4 to 6 cm) for loose
waves.
WARNING:
• Before cleaning remove the mains lead from the socked.
TIPS:
•
When you are done shaping your curls, let the hair cool
off completely before continuing with the styling.
•
For intensive curls, do not brush your hair afterwards.
Get it into shape with your fingers.
•
For a wavy, voluminous look, gently brush your curls with
a brush.
1. Comb or brush your hair to untangle it.
2. Take a strand of hair and pull it carefully downwards until it
is taut.
3. Clamp the curling tongs to the end of the strand and turn
the curl upwards.
4. Release the curling tongs again after approximately
5 seconds and continue with the next strand of hair.
5. Let the curl cool down.
6. Repeat steps 2 to 5 for more curls.
Switch-off
After use, slide the switch to position "0" and disconnect from
the mains.
Storage
Leave the device to cool before putting it away!
To do so, place the appliance with the stand onto a heat-
resistant, stable and level surface.
Mains Cable
•
Do not wrap the mains cable around the appliance.
This may result in the cable breaking.
•
Check the mains cable regularly for damagen.
Cleaning
29