Operation - Husky H4435 Mode D'emploi

Operation

1
Operating the impact wrench
□ This 1/2 in . Impact Wrench is designed to operate on
90 PSIG . Lower pressure (below 90 PSIG) will reduce
performance of the tool . Higher air pressure (over 90
PSIG) raises the performance of the tool beyond its rated
capacity and could cause serious damage to the tool and
the user .
3
Changing the output torque level
□ This tool features an air regulator located on the trigger to
manage the output power .
□ Turn the knob to adjust to your desired torque level . (1,2,3)
□ One (1) is the lowest power level, two (2) is a medium
power level, and three (3) is the highest power level .
2
Changing the output torque direction
□ This tool features a side mounted F/R (forward and reverse)
lever behind the trigger to change the output torque
direction to tighten (assemble) or loosen (disassemble) the
bolt or fastener .
□ Control the output torque direction by flipping the
directional switch to the forward arrow or reverse arrow .
4
Installing and removing the impact
sockets
WARNING: Disconnect the tool from the air supply before
servicing or changing accessories . Always use sockets rated
for impact wrenches .
To install the impact socket:
□ Disconnect the tool from the air source .
□ Select the suitable and desirable socket size .
□ Press fit the anvil into the socket .
□ To remove the impact socket:
□ Disconnect the tool from the air source .
□ Use your hand or a suitable tool to remove the socket .
6