Operation - Husky H4425 Guide D'utilisation Et D'entretien

Operation

1
Operating the impact wrench
□ This 3/8 in. Impact Wrench is designed to operate on
90 PSIG. Lower pressure (below 90 PSIG) will reduce
performance of the tool. Higher air pressure (over 90
PSIG) raises the performance of the tool beyond its rated
capacity and could cause serious damage to the tool and
the user.
3
Changing the output torque level
□ This tool features an air regulator to manage the output
power located on the back of the housing.
□ Turn the knob to adjust to your desired torque level.
□ To the left means lowest power, center is medium power
and right is high power.
2
□ This tool features a reverse switch to change the
□ Control the output torque direction by turning the reverse
4
To install the impact socket:
□ Disconnect the tool from the air source.
□ Select the suitable socket size.
Forward
□ Press fit the anvil into the socket.
□ To remove the impact socket:
□ Disconnect the tool from the air source.
□ Use your hand or a suitable tool to remove the socket.
7
Changing the output torque direction
output torque direction to tighten (assemble) or loosen
(disassemble) the bolt or fastener.
switch button to the Forward arrow or Reverse arrow
position to change the direction.
Installing and removing the impact
sockets
WARNING: Disconnect the tool from the air supply before
servicing or changing accessories. Always use sockets rated
for impact wrenches.
Please contact 1-888-43-HUSKY for further assistance.
HUSKYTOOLS.COM