Publicité
Les langues disponibles
Les langues disponibles
FILLING OF MEDICAMENT TANK
It is recommended to clean the bottle daily and sterilize it in autoclave. Sterilization must be carried out at max.
135°C, and then the bottle must be left 20 minutes to cool slowly down.
FILLING OF PHYSIOLOGICAL SOLUTION
Proceed as above explained as to opening the side panel and pulling the glass tank off the chassis.
Remove the plug and pour the physiological solution in.
To close back the shutter, push it against the cuspidor until the click is heard.
Close back the cuspidor wall.
Once the tank has been emptied and before filling up with new physiological solution, it is recommended to switch the
water supply to mains (yellow pilot light over the key
off), and then have sprays and syringe water operated for about 2'.
Such operation can avoid the layering of jellies favourable to bacteria development.
It is recommended to clean the bottle daily and sterilize it in autoclave. Sterilization must be carried out at max.
135°C, and then the bottle must be left 20 minutes to cool slowly down.
IMPORTANT: preset
the yellow pilot light over the key on before starting this operation.
Tilt the unit wall as shown for cleaning of the suction filter.
Turn the lever rightwards as indicated: the side shutter shall swing
outwards.
Accompany its movement until it rests in tilted position.
Pull the glass tank out, so as to make it easy to open its plug.
Remove the plug and pour 12 ml. of the appropriate solution by means
of the proper dispenser.
Close the plug and turn the tank towards inside.
On the keyboard, press the violet key:
The self-filling of the tank will operate automatically and will take about
one minute.
To close back the side shutter, push it against the cuspidor side until
the click is heard.
A beep shall indicate that the tank is full. Close then the tilting wall.
SELECT
MAINTENANCE
SELECT
SELECT
MAINTENANCE
55
Publicité
