eurodent ISOPLUS 22 Mode D'emploi page 51

MINI LED LIGHT CURE MODULE
1
2
3
4
5
Do not point the instrument light towards the eyes.
Do not use this instrument if the patient and/or the operator has a heart stimulator or pacemaker.
Do not use on person who suffers, or has suffered in the past, from photo-biological reactions (including urticaria
solaris or protoporphyrie erythropetique), or any person receiving medical treatment and using photosensitive
medication (including methoxsalenes or dymethylchlorotetracycline).
Any person who has previously suffered from a retina or crystalline condition or who has undergone eye surgery,
in particular cataract treatment, should visit an eye specialist before undergoing treatment with Mini Led. Even
with the patient's agreement, it is highly recommended to use protective glasses at all times.
3) By a slight traction, remove the light bulb from its slot.
4) Remove the bulb from the contacts p.c.b.
5) To reassemble, follow the above steps from 4) to 2).
Do not touch with fingers the hollow side of the bulb reflector!
This module has no programmable functions and is independent
from the foot control.
For starting the instrument, press the push-button 5 placed on the
side of the optical terminal. The green led placed underneath will light
up, enabling the instrument working.
The polimerization cycle begins pressing the key according to the
selected mode. The cycle can be interrupted at any time pressing the
key again. Cycle start and end are indicated by an acoustic signal.
There are three working modes selectable with the navigation key 1.
Fast Curing
If it is selected, the red led, placed near the symbol 4,
will lit.
The lamp will work for 10 s with a power of 1100 W/cm
the tip of ø7.5 mm.
Pulse Curing
If it is selected, the orange led, placed near the symbol 3, will lit.
The lamp will work at maximum power with 10 emissions alternating
with a rest period of 250 ms.
Step Curing
If it is selected, the jellow led, placed near the symbol 2, will lit.
The lamp will reach full power progressively in 10 s, then it will remain
on at maximum pressure for other 10 s.
The optical tip is autoclavable according to the indications given at
page 50.
MODULES
2
(110%) with
49