eurodent ISOPLUS 22 Mode D'emploi page 54

When the message appears, it is accompanied by three beeping sounds.
By pressing once the key:
the alarm (except for AL07) goes off.
If the cause of the alarm message is not settled after pressing the ENTER key, the message itself will not appear any
more until the next switching on of the unit; if the cause of the alarm message stops and then starts again, the message
will again appear.
ATTENTION: Before calling the Technical Service, try to switch off the unit and to switch it on again.
17
PARAMETERS PRESETTING
Some programmations are made once in a certain period or once for ever, and do not need continuous
variations afterwards. Such programmable parameters are not accessible from the operator keyboard when
the unit is in working mode, and must be reached through a separate procedure.
There are 4 parameters:
persistence of cold light after foot-switch release,
persistence of automatic c.b. after foot-switch release,
bowl flush time,
wet-line suction with amalgam separator.
To access the parameters setting mode, keep the:
key pressed and switch on the unit, then release the key.
The display will show P008, where "P" stands for parameters mode, "0" is the first changeable parameter,
and the two numbers at right translate the value of such parameter. To change this value, (between 00 and
99), the keys:
must be pressed. To shift to parameter 1, press the ALARM/CLOCK key; after P3, P0 is shown again.
To get out of the parameters mode and start working, press the key:
THE FOUR PARAMETERS ARE THE FOLLOWING:
52
End-operation cold light time (in seconds)
End-operation automatic c.b. time (in seconds)
Bowl flush time (in seconds)
Wet-line suction with amalgam separator
ENTER
ALARM/CLOCK
ENTER