eurodent ISOPLUS 22 Mode D'emploi page 44

to adjust its max., press the key once so that the red light starts blinking; then push:
until the desired N% gets displayed, and then start working.
If you want to store in memory the new max. power, just press once the key:
that shall confirm storage by blinking once; the instrument replaced, when picking it up again the new max.
value shall appear on the two rightwards cells of the display.
The violet key:
permits to adjust the light intensity of the fibre optics handpiece that has been picked up, from a minimum "0"
to a maximum of "9".
When releasing the Foot-control, the light persists during a certain time; such time can be adjusted according
to the procedure explained in the section "PARAMETERS PRESETTING" at page 52, and is the same time
for each of the fibre optics handpieces.
The light intensity must be adjusted according to the same procedure explained for the key POWER; the
intensity lever shall appear on the first cell of the display.
The violet key:
permits to choose the rotation mode (clockwise/reverse) of the micromotor.
Once the key has been pressed and the pilot light is blinking, by pushing:
the reverse mode gets preset
and the mark "r" (reverse) appears on the third cell of the display;
to the clockwise mode, return
the key:
the key:
must also be used to select the operation mode of the electronic surgery (see at page 50).
42
FIBRE OPTICS ADJUSTMENT
4
MODE
5
must be pressed
MODE
5
SPRAY KEY
Yellow light = water
Green light = air
Lights off ø = nothing
Yellow and green lights =
both water and air
or
TABLE "A"
AUTO C.B. KEY
choice restricted to:
Yellow light = water or
ø = nothing
Green light = air or
ø = nothing
ø = nothing
Yellow light = water or
Green light = air or
ø = nothing or
Yellow and green lights =
both water and air