Operating The Dust Sensor; Resetting The Overload Protector - Samsung SC11H4050V Serie Mode D'emploi

operating the dust sensor

SC12H4070P SERIES

resetting the overload protector

SC12H4070P SERIES
1
The overload protector shuts off the power
brush motor if the motorized brush becomes
obstructed. To reset the overload protector, use
a pen tip to press the reset switch.
caution
X The power brush work is set to turn off after 30 minutes in order to prevent from an overload.
X Indicates the amount of dust being picked up and passing by
the dust sensor which assist the user to clean more efficiently.
X The dust sensor is activated automatically by turning on the
vacuum cleaner.
✻ Green : Amount of dust passing sensor is small.
Red : Amount of dust passing sensor is large.
2
Before starting the vacuum cleaner after resetting
the overload protector, please check and clean
the motorized brush.
ENGLISH-15