Publicité
Les langues disponibles
Les langues disponibles
for cleaning.
• Keep the handles free of oil so that you can
• Clean the equipment as required with a damp
cloth and, if necessary, mild washing up
liquid.
• If you are not going to use the pole saw for an
extended period of time, remove the chain oil
and the cutter bar into an oil bath and then
wrap them in oil paper.
Important!
Always pull out the spark boot plug each time
before carrying out any cleaning. Never immerse
the equipment in water or other liquids in order
to clean it.
Store the pole saw in a safe and dry place out of
the reach of children.
10.2 Storage
Important: Never put the equipment into storage
for longer than 30 days without carrying out the
following steps.
Storing the equipment
If you intend to store the equipment for longer
than 30 days, the equipment must be prepared
accordingly. Otherwise the fuel still remaining in
the carburetor will evaporate and leave a rubbery
sediment. This can cause problems when starting
up the equipment and may require expensive
repairs.
1. Slowly remove the fuel tank cap to release
any pressure that may have formed in the
tank. Carefully empty the tank.
2. To remove the fuel from the carburetor, start
the engine and let it run until the equipment
stops.
3. Leave the engine to cool (approx. 5 minutes).
4. Remove the spark plug (see section 9.5).
5. Add one teaspoon of 2-stroke engine oil into
the combustion chamber. Slowly pull the starter
cord several times to apply a layer of oil
to all internal components. Fit the spark plug
again.
For Customer Service:
Please call 877-713-3189 (Toll Free), or email: Support@fot-usa.com
Note: Store the equipment in a dry place and
far away from possible ignition sources such as
dryer, etc.
Putting the equipment back into operation:
1. Remove the spark plug (see section 9.5).
2. Quickly tug on the starter cord to remove
excess oil from the combustion chamber.
3. Clean the spark plug and check that the
electrode gap is correct, or insert a new spark
plug with the correct electrode gap.
4. Prepare the equipment for operation.
5. Fill the tank with the relevant mixture of fuel
and oil. See the section „Fuel and oil".
10.3 Transport
To transport the machine, empty the petrol tank
the equipment with a brush or hand brush.
Dismantle the drive rod mechanism as described
in section 5.2.
11. Disposal and recycling
The equipment is supplied in packaging
to prevent it from being damaged in
transit. The raw materials in this packaging
can be reused or recycled. The equipment and its
accessories are made of various types of material,
such as metal and plastic. Defective components
must be disposed of as special waste. Ask your
dealer or your local council.
15
Publicité
