Publicité
Les langues disponibles
Les langues disponibles
length changes. It is important therefore to check
the chain tension at least every 10 minutes and
to adjust it again as required. This applies in
particular to new saw chains. When you have
will shorten when it cools down. This will help to
prevent damage to the chain.
5.5 Fitting the additional handle
Fit the additional handle as shown in Fig. 17-18.
6. Before starting
Each time before use, check the following:
• That there are no leaks in the fuel system.
• That the equipment is in perfect condition and
that the safety devices and cutting devices
are complete.
• That all screws are securely fastened.
• That all moving parts move smoothly.
6.1 Fuel and oil
Recommended fuels
Use only a mixture of unleaded petrol and special
2-stroke engine oil. Mix the fuel mixture as
indicated in the fuel mixing table.
Important: Do not use a fuel mixture which has
been stored for longer than 90 days.
Important: Never use 2-stroke oil with a
recommended mixing ratio of 100:1. The
manufacturer's warranty will be voided in case of
engine damage due to inadequate lubrication.
Important: Only use containers designed and
approved for the purpose to transport and store
fuel.
Pour the correct quantities of petrol and 2-stroke
oil into the mixing bottle (see scale printed on
the bottle). Then shake the bottle well.
6.2 Fuel mixing table
Mixing procedure: 40 parts petrol to 1 part oil
Petrol
1 liter
5 liters
For Customer Service:
Please call 877-713-3189 (Toll Free), or email: Support@fot-usa.com
2-stroke oil
25 ml
125 ml
11
6.3 Chain lubrication
Important! Never operate the chain if it is not
lubricated with saw chain oil. Use of the pole saw
without saw chain oil or if the oil level is below
the „min" mark will damage the pole saw.
Important!
Be aware of the temperature onditions:
temperatures.
At lower temperatures you will need
viscosity oil is used during the summer it will
become even thinner due to the ambient
temperatures alone, and as a result the
chain to overheat and become damaged. In
addition, the chain oil would burn and produce
unnecessary pollutants.
Filling the oil tank (Fig. 1):
Place the pole saw on a at surface. Clean the
a
rea around the oil tank cap (Fig. 3a) and then
clean the oil tank cap.
Fill the tank (Item 3a) with saw chain oil. In the
process, make sure that no dirt enters the tank,
as this could cause the oil nozzle to become
blocked. Close the oil tank cap.
7. Operation
Please note that the statutory regulations
location to another.
7.1 Starting with a cold engine
Fill the tank with the required amount of oil/
petrol mix. See "Fuel and oil".
1. Set the equipment down on a hard, level
surface.
2. Press the fuel pump (primer) (Fig. 2/Item 26)
10 times.
4. Set the choke lever (Fig. 2/Item 16) to "START".
Publicité
