Unpacking; Installing The Pipettor Holder - Biohit Proline Mode D'emploi

2.

Unpacking

The Biohit Proline pipettor package contains the following items:
1. Pipettor
2. Calibration/Opening tool
3. Grease
4. Instructions for use
5. Pipettor holder
6. Tip
7. Identification stickers
8. Caps for colour coding (excludes fixed volume pipettors)
9. Filters (pipettors > 10 µl)
10. Performance certificate according to ISO 8655-6
3.

Installing the pipettor holder

For convenience and safety always keep the pipettor vertically on its
own holder when not in use. When installing the holder, please follow
the instructions below:
1. Clean the shelf surface with ethanol.
2. Remove the protective paper from the adhesive tape
3. Install the holder as described in Figure 2A.
(Make sure the holder is pressed against the edge of the shelf.)
4. Place the pipettor onto the holder as shown in Figure 2B.
Fig. 2A
Fig. 2B
Note: An ergonomic, convenient carousel stand for 5 Biohit Proline
pipettors is also available (Cat. No.721000) (Fig. 3).
Fig. 3.
5