Control Panel And Features; Start/Pause Button - Crosley W10338608D Guide D'utilisation Et D'entretien

CONTROL PANEL AND FEATURES

1
1
WATER LEVEL
Select the setting most suitable for your load. Small will
add a low amount of water for smaller loads and Super
will add the most amount of water for large or bulky loads.
Items need to move freely. Tightly packing can lead to poor
cleaning performance, and may increase wrinkling and
tangling.
2
WASH TEMPERATURE
Wash Temperature senses and maintains uniform
water temperatures by regulating incoming hot and
cold water.
Select a wash temperature based on the type of fabric
and soils being washed. For best results and following
the garment label instructions, use the warmest wash
water safe for your fabric.
• Warm and hot water will be cooler than what your
previous washer provided.
• Even in a cold and cool water wash, some warm water
may be added to the washer to maintain a minimum
temperature.
3 OPTIONS
The following options may be added to most cycles.
ONE RINSE
This option is used to limit a cycle to one rinse.
2ND RINSE
This option can be used to automatically add a second
rinse to most cycles.
FABRIC SOFTENER ADDED – ONE RINSE
This option must be selected if using fabric softener
during a cycle. It ensures that fabric softener is added
at the correct time in the rinse for even distribution.
FABRIC SOFTENER ADDED – 2ND RINSE
This option turns on both the Fabric Softener and
the 2nd Rinse options.
4
2 3
Not all features and options are available on all models.
Appearance may vary.
WASH CYCLE KNOB
4
Use the Wash Cycle knob to select available cycles on your
washer. Turn the knob to select a cycle for your laundry load.
See "Cycle Guide" for detailed descriptions of cycles.

START/PAUSE BUTTON

5
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several
minutes to unlock the lid. Press and hold for 3 seconds
to cancel a cycle.
CYCLE STATUS LIGHTS
6
The Cycle Status Lights show the progress of a cycle.
At each stage of the process, you may notice sounds or
pauses that are different from traditional washers.
FILL
When the START/PAUSE button is pressed, the water will
enter washer briefly, pause, and then lock before sensing
process begins. The washer will use spins to check for
load balance. The sensing process may take 2-3 minutes
before steady flow of main wash water. You may hear the
hum of the spins before filling. This is normal.
WASH
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle.
The wash time is determined by the selected soil level.
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the
motor turning on briefly (short hum) to move the basket
while filling. Fabric softener will be added if the Fabric
Softener Added option was selected.
Some cycles use spray rinsing. After draining and
spinning out wash water, the washer will continue to spin
and spray in rinse water for the entire rinse time.
4
6
5