Publicité
Les langues disponibles
Les langues disponibles
Turning the Ice Maker On/Off
The On/Off switch is located on the top right-hand side of the freezer
compartment.
To turn on the ice maker, slide the control to the ON (left) position.
To manually turn off the ice maker, slide the control to the
OFF (right) position.
NOTE: Your ice maker has an automatic shutoff. The ice maker
sensors will automatically stop ice production, but the control will
remain in the ON (left) position.
Removing and Replacing the Ice Storage Bin
1. Hold the base of the storage bin with both hands and press the
release button to lift the storage bin up and out.
NOTE: It is not necessary to turn the ice maker control to the
OFF (right) position when removing the storage bin. The sensor
cover ("flipper door") on the left wall of the freezer stops the ice
maker from producing ice if the door is open or the storage bin is
removed.
2. Replace the storage bin on the door and
push down to make sure it is securely in
place.
Water Filtration System
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status Light
The filter status light will help you know when to change your
water filter.
The light will appear in yellow on the dispenser display
screen when it is almost time to change the filter.
The following accessories are available for your refrigerator. To order an
accessory, call 1-800-442-9991 and ask for the part number listed or
contact your authorized Whirlpool dealer. In Canada, call
1-800-807-6777.
®
affresh
Stainless Steel Cleaner:
Order Part #W10355016
In Canada, order Part #W10355016B
It is recommended that you replace the filter when the status light
changes to red OR water flow to your water dispenser or ice maker
decreases noticeably.
NOTE: The filter should be replaced at least every 6 months
depending on your water quality and usage.
Resetting the Filter Status
After changing the filter, reset the filter status light by pressing
FILTER RESET.
The status light will turn off when the system is reset.
Changing the Water Filter
1. Locate the water filter cover door in the base grille, and pull open
the filter door. The filter will be released and then be ejected as the
door is opened.
2. When the door is completely open, pull the filter straight out.
NOTE: There may be some water in the filter. Some spilling may
occur. Use a towel to wipe up any spills.
3. Take the new filter out of its packaging and remove the covers from
the O-rings. Be sure the O-rings are still in place after the covers
are removed.
4. With the arrow pointing to the left (toward the filter cover door's
hinge), align the new filter with the filter housing and slide it into
place. The filter cover door will automatically begin to close as the
new filter is inserted.
5. Close the filter cover door completely in order to snap the filter into
place. You may need to press hard.
6. Flush the water system. See "Water and Ice Dispensers."
ACCESSORIES
affresh
®
Order Part #W10355049
In Canada, order Part #W10355049B
affresh
®
Order Part #W10355010
In Canada, order Part #W10355010B
Water Filter:
Order Part #W10295370A (P4RFWB)
5
A
A. Water filter cover door
Stainless Steel Wipes:
Kitchen & Appliance Cleaner:
Publicité
