Pro-User APB220 Mode D'emploi page 5

1. Remove the rear license plate, and then loosen the license plate bolts/screws.
2. Position the supplied mounting plates (with camera together) behind the license plate
bracket. Secure both license plate bracket and mounting plates with the license plate
bracket bolts/screws.
3. Mount the license plate on the license plate bracket.
4. Choose a routing path for the camera's power cable through the vehicle's body to the
reverse light circuit. If in doubt, seek professional installation assistance.
5. Some vehicles may have a hole available to pass the wire through, such as where the
license plate light is mounted, or you can drill a hole close to where the power cable
is attached to the camera. Once you have chosen where the cable will enter the
vehicle's body, remove the camera. If you are able to use an existing opening, skip
the next two steps.
6. Before you drill a hole you MUST CHECK and see WHAT IS BEHIND WHERE YOU ARE
DRILLING. If there are any vehicle components, such as electrical parts or fuel
system components behind where you are drilling, you must take whatever
precaution is necessary not to damage them. Remove the license plate and camera
before drilling.
7. After you have drilled the hole, insert the supplied grommet, then pass the camera
cables through the grommet into the vehicle. You must use the grommet to prevent
the metal edge of the hole from cutting the camera cable.
8. Mount the transmitter box inside the trunk. Connect the camera's power cable and
the transmitter box power cable to the transmitter box.
9. Next you'll need to find the vehicle's reverse lights. Turn the vehicle's ignition key to
the accessory position, engage the parking brake and put the car in reverse. Look at
the vehicle's tail lights to see where the reverse lights are located, they are the white
lights. To locate the reverse light's 12V+ wire it will be necessary to gain access to
5