Installation
■
Disconnect the appliance from
the mains for:
■
Maintenance and cleaning
work
■
Adjustment work
■
Transport
■
Interruptions in work
■
Faults
■
Do not touch the splitting
wedge.
4 INSTALLATION
4.1
LSH 4
The LSH 4 log splitter is delivered fully as-
sembled and can be put into operation immedi-
ately.
4.2
LSH 6 (03 – 05)
On the LSH 6 log splitter, the pedestal has to be
fitted before the machine is put into operation.
WARNING!
Risk of injury if as-
sembly is not carried out
completely
Operation of an incom-
pletely assembled appli-
ance can result in serious
injury and damage to the
appliance.
■
Do not operate the ma-
chine until it has been
fully assembled.
442309_a
WARNING!
Risk of injury due to ap-
pliance instability
If the base is not as-
sembled correctly, the ap-
pliance can tip over and
cause serious injuries or
be damaged.
■
Assemble the base as
described below.
NOTE
The tools required for assembly are not
included in the scope of supply.
Remove the wheels (03/a)
1. Pull both protective caps (03/7) off shaft
(03/2).
2. Remove both C-clips (03/6) from the shaft.
3. Pull both wheels (03/1) off the shaft.
Remove pedestal (03/b)
1. Unscrew all four nuts (03/3) on the inside of
the pedestal (03/5).
2. Pull all four carriage bolts (03/4) out of the
pedestal.
3. Remove the pedestal from the log splitter.
Assemble the base (04)
1. Push longitudinal strut (04/2) through cross-
strut (04/1) in such a way (04/a) that it pro-
trudes by approx. 10 cm at the other end.
2. Insert the free end of the longitudinal strut
(04/b) into front leg (04/3).
3. Secure the connection using a hexagon bolt
(04/4).
4. Push wheels (04/6) onto both shafts (04/5) of
the cross-strut (04/c).
5. Push C-clips (04/7) onto both shafts so that
they engage.
6. Pull protective caps (04/8) onto both shafts.
Mount log splitter on base
1. Push both rear legs (05/8) onto shaft (05/1)
of the log splitter (05/a).
2. Secure each rear leg with a hexagon bolt and
a nut (05/9).
33